|
|
Line 13: |
Line 13: |
|
| |
|
| ''NOTE: Ubuntu releases before 14.10 provide Bluez 4.101 '''without''' Wiimote Plus patch. You need to patch Bluez yourself !'' | | ''NOTE: Ubuntu releases before 14.10 provide Bluez 4.101 '''without''' Wiimote Plus patch. You need to patch Bluez yourself !'' |
| == Connecting ==
| |
| taken from bluez sources /plugins/wiimote.c:
| |
| /*
| |
| * Nintendo Wii Remote devices require the bdaddr of the host as pin input for
| |
| * authentication. This plugin registers a pin-callback and forces this pin
| |
| * to be used for authentication.
| |
| *
| |
| * There are two ways to place the wiimote into discoverable mode.
| |
| * - Pressing the red-sync button on the back of the wiimote. This module
| |
| * supports pairing via this method. Auto-reconnect should be possible after
| |
| * the device was paired once.
| |
| * - Pressing the 1+2 buttons on the front of the wiimote. This module does
| |
| * not support this method since this method never enables auto-reconnect.
| |
| * Hence, pairing is not needed. Use it without pairing if you want.
| |
| * After connecting the wiimote you should immediately connect to the input
| |
| * service of the wiimote. If you don't, the wiimote will close the connection.
| |
| * The wiimote waits about 5 seconds until it turns off again.
| |
| * Auto-reconnect is only enabled when pairing with the wiimote via the red
| |
| * sync-button and then connecting to the input service. If you do not connect
| |
| * to the input service, then auto-reconnect is not enabled.
| |
| * If enabled, the wiimote connects to the host automatically when any button
| |
| * is pressed.
| |
| */
| |
|
| |
|
| |
|
| = Mac OS X = | | = Mac OS X = |